Zhone 2000 ユーザーズマニュアル
2000-A2-GB20-10
- 155 -
February 2004
This chapter describes the tasks required to configure the Dynamic Host
Configuration Protocol (DHCP) server on the LAN connection.
Configuration Protocol (DHCP) server on the LAN connection.
DHCP allows for dynamic allocation of network addresses and
configurations to newly attached hosts. DHCP reduces the work required
to administer a large network.
configurations to newly attached hosts. DHCP reduces the work required
to administer a large network.
This chapter contains the following topics:
Basic DHCP Server setup tasks (page
)
Using the DHCP Server Configuration Menu (page
)
Enabling DHCP Server (page
Checking for Additional DHCP Servers (page
)
Configuring DHCP Server parameters (page
Configuring the DHCP Address Range Pool (page
)
Configuring DHCP Client Entries (page
)
Displaying DHCP Server details (page
)
Displaying DHCP Server statistics (page
Displaying DHCP Server assigned/unassigned addresses (page
Displaying DHCP Entry details (page
Deleting a DHCP Client entry (page
Deleting a DHCP Assignment entry (page
)
Basic
DHCP
Server
Setup
Tasks
DHCP
Server
Setup
Tasks
When DHCP is enabled, it dynamically assigns an IP address to each
device assigned to the DHCP server on the IAD. You must identify the
Ethernet Interface to correctly implement DHCP Server on your IAD.
device assigned to the DHCP server on the IAD. You must identify the
Ethernet Interface to correctly implement DHCP Server on your IAD.
You must complete at least these tasks to configure the DHCP server:
Enable DHCP (default is disabled)
Configure the DHCP server parameters
Configure the DHCP address range pool
'+&36HUYHU
&RQILJXUDWLRQ
NOTE
When the IAD prompts you for input, the current value is
displayed in parentheses. To conveniently accept the current
value, just press Enter.
displayed in parentheses. To conveniently accept the current
value, just press Enter.