Zhone 2000 ユーザーズマニュアル

- 53 -

If you are setting up voice and data channels, you can select ATM or 
Frame Relay as you set up the channels, in the section Setting Up TDM 
Voice, following.

To select ATM or Frame Relay as the datalink protocol:

1. On the WAN Configuration menu, type 1 to select Configure Datalink 

Protocol.

2. The IAD displays the WAN Datalink Protocol Configuration menu, 

identifying the current datalink protocol just below the banner.

When you select ATM as the datalink protocol, the IAD displays the ATM 
and PVC options on the WAN Configuration menu:

When you select Frame Relay, the IAD displays the Frame Relay options 
on the WAN Configuration menu:

 

You must sign on as Supervisor to configure the WAN 
interface.

Be sure to reset the IAD when you are done making changes 
to WAN settings. Resetting the IAD causes the configuration 
changes to take effect.

*********************************************

WAN Datalink Protocol Configuration Menu

*********************************************

 Current DataLink Protocol: Frame Relay

6. ATM
7. Frame Relay

LAN LINK

LAN ACT

WAN LINK

VOICE

POWER

JF2000 and JF2100 series IADs do not support Frame Relay.

*****************************************

WAN Configuration Menu

*****************************************

Configuring G2237 xDSL

1. Configure Datalink Protocol
2. Configure Physical Interface
3. Configure PVCs
4. Configure ATM Options

Options 3 and 4 
display ATM 
configuration options