Zhone 5100 参照マニュアル
CHAPTER 3
Interfaces
Interfaces
72
Vpacket 5100/6100 Series Reference Manual
In this example, the current T1 WAN interface statistics are shown.
Viewing the WAN state
You can view the state of the WAN interface, which can be up, down, or loopback, by issuing the
show wan state command.
Syntax: show wan state
Example:
Syntax: show wan state
Example:
------------------- PPP 2 Statistics ----------------------
Bad Addresses : 0
Bad Controls : 0
Packets Too Long : 0
PPP link failures : 0
------------------- MLPPP Statistics ----------------------
Packets Too Long : 0
Transmitted Fragments : 0
Received Fragments : 5942766
Dropped Packets : 0
Transmitted Packets : 2986490
Received Packets : 2983766
VPacket#
VPacket# show wan state
----------------- T1 Interface 1 Status -------------------
Link state : up
Frame Sync : Yes
Loop Back : None
Yellow Alarm (Near RAI) : No
Blue Alarm (Near AIS) : No
Yellow Alarm (Far RAI) : No
Blue Alarm (Far AIS) : No
----------------- T1 Interface 2 Status -------------------
Link state : up
Frame Sync : Yes
Loop Back : None
Yellow Alarm (Near RAI) : No
Blue Alarm (Near AIS) : No
Yellow Alarm (Far RAI) : No
Blue Alarm (Far AIS) : No
(Continued)