Zhone 5100 ユーザーガイド
CHAPTER 4
Settings options
Settings options
42
Vpacket 5100/6100 Series Web Interface Manual
Editing the MGCP end point
From this window you can set and view the current settings for the MGCP end points. Each
telephony channel on the system is an MGCP end point. The configurable MGCP end point
parameters include:
•
•
Index number A unique, sequentially numbered identifier for this terminal
•
Terminal Name A human-readable name.
•
Digit Map Using the North American Dialing Plan, this field lets you set a up a digital
mapping configuration similar to the use of the CLI command set tcid [tcid]
default_digit_map <digit_map_string> where [0-9]xxx: the bracketed numbers supply a set
of valid numbers–separated by commas–which precede the local dialing number.; 91x.T:
these parameters allow for a PBX dial-out both locally and across area codes (the x and the 1,
respectively); the “.T” signifies a duration in seconds during which the digits must be dialed or
a fast busy signal occurs; and 9011x.T: these parameters allow for a PBX dial-out for
international calls.
mapping configuration similar to the use of the CLI command set tcid [tcid]
default_digit_map <digit_map_string> where [0-9]xxx: the bracketed numbers supply a set
of valid numbers–separated by commas–which precede the local dialing number.; 91x.T:
these parameters allow for a PBX dial-out both locally and across area codes (the x and the 1,
respectively); the “.T” signifies a duration in seconds during which the digits must be dialed or
a fast busy signal occurs; and 9011x.T: these parameters allow for a PBX dial-out for
international calls.
•
Mode Operational mode of the terminal. Can be dynamic or static.
•
MGC Index Sequential numbered value for this session.
Figure 4-15. MGCP Terminal Configuration window