Zhone 2004 ユーザーガイド
7-4
2 0 0 0 - A 2 - G B 2 2 - 0 0
Ring lines concurrently or sequentially? (CS or
ESC): s
ESC): s
3
Type “S” to perform the test sequentially, or type “C” to perform the test
concurrently. The IAD displays information about the test progress:
concurrently. The IAD displays information about the test progress:
Press a key to end ring test...
Ringing onhook lines...
Ringing onhook lines...
Line 1 2 3 4 5
6 7 8
6 7 8
top ringing all lines...
Line 1 2 3 4 5 6 7 8
Ring test complete
Line 1 2 3 4 5 6 7 8
Ring test complete
4
Press any key to terminate the test. The IAD displays the POTS Diagnostics
menu.
menu.
5
Continue with other tests, or press Escape twice to return to the Main menu.
On/Off Hook Test
The On/Off Hook test reports the hook state of each voice port line. To
perform an On/Off Hook test, follow the steps below.
perform an On/Off Hook test, follow the steps below.
1
Type “O” on the POTS Diagnostics menu to select On/Off Hook Test. The
IAD displays the status of the test as it runs in real time:
IAD displays the status of the test as it runs in real time:
2
Press Enter to terminate the test. The IAD displays the POTS Diagnostics
menu.
menu.
The following tests listed on the POTS Diagnostics menu (Figure 7.2) are
reserved for Paradyne engineers:
reserved for Paradyne engineers:
I. Infineon Codec Test
T. Test External DSP Memory
Troubleshooting the IAD
This section provides information for troubleshooting symptoms associated
with the operation of the IAD. The table below describes symptoms and
probable causes, and suggests what action can be taken to correct the
problem.
with the operation of the IAD. The table below describes symptoms and
probable causes, and suggests what action can be taken to correct the
problem.