Zenith h27e44dt 操作ガイド
P A G E 1 0
Hook Up Cable Service (CATV) and VCR
Connect a VCR and Cable service to the Presentation TV
Tune the VCR and television tuned to channel 3 or
4 and use the cable box to change channels.
4 and use the cable box to change channels.
No A/V cables are included with your Presentation
TV. Without A/V cables, most VCRs will not play
videocassettes in stereo sound.
TV. Without A/V cables, most VCRs will not play
videocassettes in stereo sound.
TV Back
S-Video
In
M.P.I.
R- Audio - L
In
S-Video
Out
Antenna
Cable
Video
In
Matrix
Out
R- Audio - L
In
In
Out
Audio
Video
3 4
VCR Back
VCR Back AV Panel
output
switch
A/V cables
not included
with TV
Cable TV
Wall Jack
Cable Box
In
Out
RF Coaxial Wire
(75 ohm)
3 4
output
switch
TV Back
S-Video
In
M.P.I.
R- Audio - L
In
S-Video
Out
Antenna
Cable
Video
In
Matrix
Out
R- Audio - L
In
In
Out
Audio
Video
3 4
VCR Back
VCR Back AV Panel
output
switch
A/V cables
not included
with TV
RF Coaxial Wire
(75 ohm)
Cable TV
Wall Jack
Wall Jack
Locate the Antenna/Cable (In) jack on the
back of the VCR.
back of the VCR.
Connect the cable that runs from the wall
directly to this jack, according to one of the
diagrams shown to the right.
directly to this jack, according to one of the
diagrams shown to the right.
Remove the back of the remote and put in
two AAA batteries.
two AAA batteries.
Plug your TV in to a standard power outlet.
This TV is designed to operate on standard
current, 120-volt 60 Hertz AC. Do not
attempt to operate it on DC Current.
This TV is designed to operate on standard
current, 120-volt 60 Hertz AC. Do not
attempt to operate it on DC Current.
Go to page 14 to Auto Program the
Presentation TV.
Presentation TV.
1
2
3
4
5
back of
remote
206-3753