ZyXEL NSA-2400 ユーザーガイド

 Chapter 9 Troubleshooting

NSA-2400 User’s Guide

• Turn the NSA-2400 off, remove the disk tray and make sure:

• it is a SATA-1 compatible hard drive

• it is inserted correctly into the disk tray. Push the tray back into NSA disk bay until it 

snaps into place and push the latch up (see the NSA Quick Start Guide).

• the hard disk is not faulty. You could either try a different hard disk or test the original 

hard disk in a different NSA or computer.

• If the problem continues, contact the vendor.

V

The disk drive ALM LED is on.

• The hard disk has a problem. What you have to do is turn the NSA-2400 off and replace 

the faulty disk. See your Quick Start Guide for information on replacing a disk and also 

. After replacing the disk, turn on the NSA-2400, go to the 

Storage > Disk screen and click the Repair icon next to the new disk. If there is already 
another volume resynchronizing, then you will see Waiting Resync as the volume status. 

• If the problem continues, contact the vendor.

V

The LAN LED is off.

• Make sure the Ethernet cable is connected properly to the NSA-2400 and connected to 

another (Ethernet) device. Make sure the other device is turned on. If it’s connected 
directly to a computer, make sure that the computer network card is working (ping 
127.0.0.1 on the computer).

• Use another Ethernet cable. If you’re connecting to a Gigabit Ethernet, make sure you’re 

using an 8-wire Ethernet cable. 

• If the problem continues, contact the vendor.

See 

 for a description of NSA-2400 LEDs.

V

I forgot the IP address for the NSA-2400.

• The default IP address is 192.168.1.3. 

• Use the NDU (NSA Discovery Utility) to discover your NSA-2400. If you have admin 

privileges, you can directly change the IP address of the NSA-2400 using the NDU.