Sharp MX-2300N ユーザーガイド

This program is used to set the number of recall 
attempts and the interval between recall attempts when 
a transmission is not successful due to the line being 
busy or other reason.
The number of recall attempts can be set to any number 
from 1 to 14, and the interval between attempts can be 
set to any number of minutes from 1 to 15. Specify each 
number with the 

 keys. (To make the number 

change quickly, keep your finger on the 

 or 

 key.)

If you do not wish to have recalling take place, select the 
[Turn off Recall] checkbox 

 and touch the [OK] key.

This setting determines whether or not your machine will 
re-attempt the call if a fax transmission fails due to a line 
error.
The number of recall attempts can be set to1 and the 
interval between attempts can be set to any number of 
minutes from 1 to 15.
(To make the number change quickly, keep your finger 
on the 

 or 

 key.)

If you do not wish to have recalling take place, select the 
[Turn off Recall] checkbox 

 and touch the [OK] key.

The fax reception settings can be enabled or disabled to suit the needs of your workplace.
Touch the [Image Send Settings] key, the [Fax Settings] key, and then the [Fax Receive Settings] key to configure the 
settings.

This setting is used to select the number of rings on 
which the machine automatically receives a call and 
begins fax reception in auto reception mode. Any 
number from 0 to 15 can be selected.
Specify the number with the 

 keys and touch the 

[OK] key. (To make the number change quickly, keep 
your finger on the 

 or 

 key.)

This used to have received faxes printed on both sides 
of the paper.
When this setting is enabled and a fax consisting of 2 or 
more pages is received (the pages must be the same 
size), the pages are printed on both sides of the paper.
To enable this setting, select the checkbox 

 and 

touch the [OK] key.

When a fax is received that includes the sender's name 
and number, the received image is slightly larger than 
the standard size*. This setting is used to automatically 
reduce the image to fit the standard size.
To enable this setting, select the checkbox 

 and 

touch the [OK] key.

* Standard sizes are sizes such as 8-1/2" x 11" and 

8-1/2" x 5-1/2" (A4 and B5).

When this setting is enabled, note that your machine 
will not re-attempt a call when manual transmission or 
direct transmission is used.

When this setting is enabled, note that your machine 
will not re-attempt a call when manual transmission or 
direct transmission is used.

If you select "0" for the number of rings, the machine 
will immediately answer and begin fax reception 
without ringing in auto reception mode. 

If Auto Receive Reduce is disabled, the edges of the 
image outside the standard size will be cut off. 
However, the image will be clearer because it will be 
printed at full size.