Sharp MX-2300N ユーザーガイド

If multiple telephone numbers have been assigned to 
your telephone line, the number called can be identified 
by its ringing pattern. By using one number for voice 
calls and another number for faxes, you can tell which 
type of call you are receiving by the ringing pattern. You 
can set your machine to automatically receive faxes 
when your fax number is called by setting the pattern 
that corresponds to your fax number. Six selections are 
available. 
To use this setting, touch the key of the desired pattern 
and touch the [OK] key.

The fax send settings are used to enable or disable certain fax functions to better suit the needs of your workplace.
Touch the [Image Send Settings] key, the [Fax Settings] key, and then the [Fax Send Settings] key to configure the 
settings.

This setting is used to have the size of transmitted faxes 
automatically reduced to match the size of the paper in 
the receiving machine.
If the setting is disabled, faxes are sent at full size. 
Because the size is not adjusted to match the size of the 
printing paper, part of the received fax may be cut off.
To enable this setting, select the checkbox 

 and 

touch the [OK] key.

When transmitting an image that is one of the following 
sizes, this function rotates the image counterclockwise 
90 degrees.
8-1/2" x 11", 5-1/2" x 8-1/2"R, A4, B5R, A5R, 16K
To use this setting, select the checkboxes 

 of the

desired sizes and touch the [OK] key.

When this setting is enabled, the machine starts 
transmitting a fax as soon as the first page is scanned. 
Transmission takes place at the same time as the 
remaining pages are being scanned.
If you disable this setting, transmission will not begin 
until all pages have been scanned. Note that this setting 
does not apply to manual transmission.
To enable this setting, select the checkbox 

 and 

touch the [OK] key.

This setting is used to add the page number to the top of 
each fax page printed by the receiving machine.
To enable this setting, select the checkbox 

 and 

touch the [OK] key.

This setting determines the position of the date and 
sender information printed at the top of faxes by the 
receiving machine. To have the information printed 
outside the transmitted document image, touch the 
[Outside the Original Image] key. To have the 
information printed inside the document image, touch 
[Inside the Original Image] key.

8-1/2" x 11"R and A4R size images are not rotated.