Sharp MX-5500N 操作ガイド

The following color settings can be configured.

Color balance values obtained using "Color Balance" in 
the special modes can be stored in a program (1 to 48), 
and those values can be retrieved and stored as the 
initial color balance setting*. Use this feature when you 
want to repeatedly use a color balance setting for a 
favorite color or for correction when a change occurs in 
the color balance.
* Preset values displayed when you select "Color 

Balance" in the special modes.

Return to the Factory Default Setting
This returns the stored color balance values to the 
factory default values (all color balance values are "0" for 
the 8 levels of each color).

This is used to perform automatic color correction when 
the color in color copies is off. The machine prints a test 
patch, the test patch is scanned, and the color is 
automatically corrected.
After the [Execute] key is touched and a test patch is 
printed, a message appears prompting you to begin 
automatic calibration. Place the test patch on the 
document glass as shown below (so that the thin line at 
the edge of the page is to the left).

Lay copy paper (about five sheets) that is the same size 
as the test patch on top of the placed test patch, gently 
close the automatic document feeder, and touch the 
[Execute] key.

• Before executing Auto Color Calibration, check to 

see if the registration adjustment is correct. If the 
registration adjustment is not correct, perform 
"

" (page 62).

• If the color is still off after performing Auto Color 

Calibration, repeating Auto Color Calibration once 
again may improve the color.

Thin line