Sharp MX-5500N 操作ガイド

Network settings are described below. Touch the [Network Settings] key to configure the settings.

When using the machine on a TCP/IP network, use this 
setting to configure the IP address of the machine.
The settings are shown below.

IP Address
Enter the IP address of the machine.

IP Subnet Mask
Entry the IP Subnet Mask.

IP Gateway
Enter the IP Gateway address.

DHCP
Use this setting to have the IP address obtained 
automatically using DHCP (Dynamic Host Configuration 
Protocol). When this setting is enabled, it is not 
necessary to manually enter an IP address.

To use the machine on a TCP/IP network, this setting 
must be enabled. The IP address of the machine must 
also be configured using "

To use the machine on a NetWare network, this setting 
must be enabled.

To use the machine on an EtherTalk network, this 
setting must be enabled.

To use the machine on a NetBEUI network, this setting 
must be enabled.

This returns all "Network Settings" to the factory default 
settings.

Use this function to check if the machine can 
communicate with a computer on the network.
Specify the IP address of the desired computer and 
touch the [Execute] key. A message will appear 
indicating whether or not the computer responded.

When any of these settings are changed, you must exit the system settings, turn off the [POWER] key (

), wait a brief 

interval, and then turn the [POWER] key (

) back on to make the new settings take effect.

• If the machine will be used on a TCP/IP network, be 

sure to enable "

" below.

• If DHCP is used, the IP address assigned to the 

machine may change automatically. If the IP 
address changes, printing will not be possible.