Sharp MX-M1100 操作ガイド

Did you select the correct destination? 
Is the correct information (e-mail 
address or FTP server information) 
stored for that destination?

Make sure that the correct destination information is 
stored for the destination and that the destination is 
correctly selected. If delivery by e-mail (Scan to E-mail) 
is unsuccessful, an error message such as "Undelivered 
Message" may be sent to the designated administrator's 
e-mail address. This information may help you 
determine the cause of the problem.

Did you place a long size original on the 
document glass when it is scanned?

A long size original cannot be scanned from the 
document glass. Place originals in the document feeder 
tray of the automatic document feeder.

Did you place an original that is folded?

If a folded original is placed in the automatic document 
feeder, an error will occur and scanning will be canceled 
when the actual original size is detected during 
scanning.
Following the instructions in the display, unfold the 
original, place it in the automatic document feeder 
again, and rescan.

Does a message appear notifying you 
that the original size was not detected?

Place the original again. If the original size is still not 
detected correctly, specify the original size manually.

Have functions been disabled by the 
administrator?

Some functions may have been disabled in the system 
settings (administrator). Check with your administrator.
When user authentication is enabled, the functions that 
you can use and page counts may be restricted in your 
user settings. Check with your administrator.

Is "Default Address Setting" enabled in 
the system settings (administrator)?

If you wish to send to a destination other than the 
default destination, touch the [Cancel] key.
If you are the administrator and wish to change or 
disable the default destination, change the settings as 
appropriate in "Default Address Setting".

➞ System Settings (Administrator) > "Image Send 

Settings" > "Scan Settings" > "Default Address 
Setting"

Is the machine's clock set to the correct 
time?

Set the clock to the correct time.

➞ System Settings > "Default Settings" > "Clock Adjust" 

> "Clock Adjust"

Is a transmission in progress?

If another transmission is in progress when the specified 
time arrives, the timer operation will begin after that 
transmission is finished.