Jet jdp-15m ユーザーガイド

 

8

 

1.  Remove the contents from the shipping 

container. 

2. Compare the contents of the shipping 

container with the list found above.  Report 
any shortages or damage to your JET 
distributor. 

3. Clean all rust protected surfaces with 

kerosene or a light solvent.  Do not use 
lacquer thinner, paint thinner, or gasoline.  
These will damage plastic components and 
painted surfaces. 

Referring to Figure 1: 

1.  Place the base (A) on a level floor. 

2.  Place the column assembly (B) on the base 

(A) and align the holes in the column 
support with the holes in the base. 

Note: The column shown in Figure 1 is for 
the JDP-15MF. While the JDP-15M column 
is slightly different in appearance, the 
assembly procedure is the same. 

3.  Using a 17mm wrench, secure the column 

(B) with four M10 x 40 hex cap screws (C) to 
the base. 

 

When shipped, the rack ring and rack are 
bundled together with the column in plastic 
wrap. 

Referring to Figures 2 and 3: 

4.  Remove the wrap and take the rack ring (D) 

and rack (B) off the column (C). 

5.  Install the table bracket (A) together with the 

rack (B) as shown in Figure 2. 

 

6.  Slide the rack ring (D) over the column (C), 

placing it so it rests against the rack (B) as 
shown in Figure 3 and tighten firmly. 

 

Referring to Figure 4 (shown already 
assembled): 

1.  Loosen the setscrew (B) on the table crank 

handle (A). 

2.  Slide the handle (A) onto the table bracket 

shaft. 

3. Turn the handle until the setscrew is 

opposite the flat section on the shaft, and 
tighten the setscrew to secure the handle. 

4. Install the table lock handle (C), but do not 

tighten.