Jet ghd-20 ユーザーズマニュアル

 

8 

  Read and understand all 

  Do not attempt to turn on 

1. Remove the contents from the shipping 

container. 

2. Compare the contents of the shipping 

container with the list on page 7.  Report any 
shortages or damage to your JET distributor. 

3. Clean all rust protected surfaces with 

kerosene or a light solvent.  Do not use 
lacquer thinner, paint thinner, or gasoline.  
These will damage plastic components and 
painted surfaces. 

 

Referring to Figure 1: 

1.  Place the base (A) on a level floor. 

2.  Place the column assembly (B) on the base 

(A) and align the holes in the column support 
with the holes in the base. 

3.  Using a 17mm wrench, secure the column (B) 

with four M10 x 40 hex cap screws (C) to the 
base. 

 

When shipped, the rack ring and rack are bundled 
together with the column in plastic wrap. 

Referring to Figures 2 and 3: 

1.  Remove the wrap and take the rack ring (D) 

and rack (B) off the column (C). 

2.  Install the table bracket (A) together with the 

rack (B) on the column (C) as shown in 
Figure 2. 

3.  Slide the rack ring (D) over the column (C), 

placing it so it rests against the rack (B) as 
shown in Figure 3 and tighten firmly with a 
3mm hex wrench (provided).