Jet ghd-20 ユーザーズマニュアル

 

9 

Referring to Figure 4: 

1.  Loosen the setscrew (B) on the table crank 

handle (A). 

2.  Slide the handle (A) onto the table bracket 

shaft. 

3.  Turn the handle until the setscrew is opposite 

the flat section on the shaft, and tighten the 
setscrew to secure the handle. 

 

 

Referring to Figure 5: 

Thread the column lock  handle (A) into the table 
bracket (B). 

 

 

The table is heavy!  This installation is a two 
person operation to avoid injury from 
accidental dropping. 

Referring to Figure 6: 

1.  Have one person hold the table (A) against 

the bracket (B), aligning the hole in the 
mounting plate of the table with the threaded 
hole in bracket. 

2.  Have the second person insert the 5/8"-11x2 

hex head screw (C) through the opening on 
the bottom side of the table (A) and start 
threading the screw into the bracket by hand. 

3.  Finish tightening the screw (C) with a 15/16" 

or wrench (wrench provided), but leave loose 
enough so the table can be tilted by hand. 

4.  Using the scale on the bracket as a guide, set 

the table angle to 0 degrees (level). 

5.  Take the locator pin (D) and adjust the hex 

nut towards the end of the thread as shown in 
the close up view (D). 

6.  Insert the non-threaded end of the locator pin 

(D) into the hole on the table found just below 
the mounting screw. Press all the way in. 

Note: The table may have to be tilted slightly 
back and forth if the holes do not quite align. 

7.  Tighten the screw (C) with a 15/16" wrench.