Jet jj-6csdx ユーザーズマニュアル

 

11

Referring to Figure 6: 

1.  Place the belt guard (A) over the opening in the 

stand. 

2.  Line up the holes in the stand with the holes in 

the guard. 

3.  Attach the guard to the stand using four 

1/4-20 x 1/2’ pan head machine screws (B) and 
four 1/4” flat washers (C). 

 

 

1. Remove 

the 

screw from the guard post. 

Referring to Figure 7: 

2. Turn spring  knob  (B) approximately one and 

one half revolutions counter-clockwise (as 
viewed from the top) and hold. 

3. Insert 

the 

guard post into hole in table.  Make 

sure that the spring inside the spring knob (B) 
engages the slot in guard post. 

4. Thread 

the 

screw (C) back into the guard post. 

5.  Check for proper operation.  The cutterhead 

guard  (A) must return fully to the fence when 
released.  If guard does not return fully, pull 
guard, apply more tension to the spring knob 
(B) by turning it another half turn counter-
clockwise, and re-insert guard.  If guard closes 
too quickly and strikes fence too hard, release 
some tension on the spring. 

6. Insert 

screw (B) back into the guard post. 

 

 

Referring to Figure 8: 

Install access cover (A) by placing bottom of panel 
in the stand and fastening with four #5-40 x 3/8" 
pan head screws and four flat washers (B). 

 

Referring to Figure 8: 

Attach the dust chute (C) to the base with four 1/4" 
x 1/2" machine screws and four 1/4" washers (D).