Jet jj-6csdx ユーザーズマニュアル

 

9

1.  Carefully finish removing all contents from both 

shipping cartons. Compare contents of the 
shipping cartons with the list of contents above. 
Place parts on a protected surface. 

2.  Report any shipping damage to your local 

distributor. 

3.  Clean all rust protected surfaces (bed, fence, 

etc.) with kerosene or diesel oil. Do not use 
gasoline, paint thinner, mineral spirits, etc. 
These may damage painted surfaces. 

4.  Apply a thin layer of paste wax to the bright 

surfaces of the fence and tables to prevent 
rust. 

5.  Set packing material and shipping cartons to 

the side. Do not discard until machine has 
been set up and is running properly. 

 

 

 

Referring to Figure 1: 

1.  Place bed assembly (A) on top of stand (B). Be 

sure the identification label (C) on the bed 
faces the same direction as the switch (D) on 
the stand. 

2.  Line up two holes in the stand top (E) with 

holes in the bed assembly by viewing through 
the access door in rear side of the stand. 

3.  Attach stand to bed assembly by using two 3/8" 

lock bolts and lock washers (Figure 2). Hand 
tighten only at this time. 

4.  Line up the third hole in the stand (F) with the 

hole in the bed assembly by viewing through 
the dust chute (G). 

5.  Install the third 3/8" lock bolt and lock washer 

through the dust chute (G) to secure the bed to 
the stand. 

6.  Tighten all three lock bolts with a 14mm 

wrench.