Jet jj-8cs ユーザーズマニュアル
9
Assembling Knife-Setting Gauge
1.
Place the two bases (A, Fig. 4) onto each end
of the bar (B, Fig. 4). Snap the four E-rings (C,
Fig. 4) into the grooves on the bar as shown.
of the bar (B, Fig. 4). Snap the four E-rings (C,
Fig. 4) into the grooves on the bar as shown.
90
°
Fence Adjustment
Note: whenever making an adjustment to the fence,
lift the fence up slightly after releasing the lock
handle to avoid scratching the table.
lift the fence up slightly after releasing the lock
handle to avoid scratching the table.
1.
Set infeed table to the same height as the
outfeed table.
outfeed table.
2.
Move the fence by releasing lock handle (A,
Fig. 5) and pushing the fence assembly until it
overlaps the tables.
Fig. 5) and pushing the fence assembly until it
overlaps the tables.
3.
Adjust the fence to a 90
°
angle by releasing
lock handle (B, Fig. 5), pulling up on handle (C,
Fig. 5), and re-tightening lock handle (B, Fig.
5).
Fig. 5), and re-tightening lock handle (B, Fig.
5).
4.
Place a combination square on the infeed table.
(Fig. 6)
(Fig. 6)
5.
If fence is not square to table, release lock
handle (B, Fig. 5), loosen nut (D, Fig. 5), and
turn bolt (E, Fig. 5) until fence is square to table.
handle (B, Fig. 5), loosen nut (D, Fig. 5), and
turn bolt (E, Fig. 5) until fence is square to table.
6.
Tighten nut (D, Fig. 5) to retain the setting.
Tighten lock handle (B, Fig. 5).
Tighten lock handle (B, Fig. 5).
Fig. 4
Fig. 5
Fig. 6