Electrolux ew36ec55g ユーザーズマニュアル

Both the 30” and 36” cooktops are equipped with “Triple” surface radiant
elements located as shown in Figs. 1 & 2. A touch key pad on the element
controls is used to select one of the 3 positions of the element. Indicator
lights on the control panel are used to indicate which coil of the triple radiant
element will heat. One indicator light on indicates that only the INNER coil
will heat (Fig. 3). Two indicator lights on indicate that both INNER and
MIDDLE coils will heat (Fig. 4). Three indicator lights on indicate that all 3
portions of the element will heat (Fig. 5). You may switch from either of
these settings at any time during cooking.

1.

Place correctly sized cookware on the radiant surface element.

2.

Touch and hold the 

 key pad until a beep sound. The power

indicator light above the 

 will turn ON. Note: If no other key

pad is touched within 20 seconds the request to Power ON the
cooktop will clear.

3.

Touch and hold the pad for the desired triple element position

until a beep is heard. The indicator light located above the 

NO

NO

NO

NO

NOTE

TE

TE

TE

TE

See the Recommended Setting for Surface Elements table, on page 12, to make the correct setting.

pad will glow. Note: If no further pads are touched within 10 seconds the request to
power the element ON will clear.

4.

Select the INNER (Fig. 3), MIDDLE (Fig. 4) or ALL 3 element (Fig. 5) to heat by

touching the 

 key pad.

5.

Touch 

 pad once to turn ON the power level to HI. Touch 

 pad once for

MEDIUM, touch 

 pad once for power level to LO or touch 

 pad once to set the

power level to KEEP WARM setting.

6.

Each touch of the 

 or 

 pad will increase or decrease the power level. Lo is the

lowest power level available. Note: The power level may be adjusted at any time while
the element is ON.

7.

Start most cooking operations on a higher setting and then turn to a lower setting to
finish cooking. Each surface element provides a constant amount of heat at each
setting. A glowing red surface heating area extending beyond the bottom edge of the
cookware indicates the cookware is too small for the surface heating area.

8.

When cooking has been completed touch the 

 pad once to turn the element OFF

and if no other surface element is used touch the 

 key pad to turn off the cooktop.

Note: The Hot Surface Indicator Light will turn ON if the cooktop is still hot and will
remain ON until the heating surface area has cooled sufficiently.