Electrolux e32ar75jp オーナーマニュアル

1.   Remove handles from carton and any other 

protective packaging.

2.   Position fresh food handle end caps over upper 

and lower preinstalled shoulder bolts (A) that are 
fastened into door.

3.   While holding handle fi rmly against door, fasten 

upper and lower Allen set screws (B) with supplied 
Allen wrench until there is no gap between handle 
and door.

To remove the toe grille, use a Phillips head 
screwdriver and remove the two screws holding the 
toe grille to the cabinet.  Then pull the toe grille away 
from the unit.

• 

The refrigerator must have all bottom corners 
resting fi rmly on a solid fl oor.

• The 

fl oor must be strong enough to support a fully 

loaded refrigerator.  

• It 

is 

VERY IMPORTANT for your refrigerator 

to be level in order to function properly.  If the 
refrigerator is not leveled during installation, 
the door may be misaligned and not close or 
seal properly, causing cooling, frost or moisture 
problems.

Leveling instructions continued on next page.

All set screws should be tightened so the screw is 
below the surface of the handle. The handles should 
be drawn tight to freezer and refrigerator doors with 
no gaps. Opening the opposite door while tightening 
the Allen screw makes installation easier.

The door handle may loosen over time or if it was 
installed improperly. If this happens, tighten the set 
screws on the handles.