Integra cdc-3.1 取り扱いマニュアル
6
Remote Controller
Remote controller
1. Open/close button ( ) [8]
2. Operation buttons
2. Operation buttons
: Pause button [9]
: Stop button [9, 11]
: Play button [8~10, 13, 14]
: Fast reverse button [9, 15]
: Fast forward button [9, 15]
: Reverse skip button [11, 14]
: Forward skip button [11, 14]
: Stop button [9, 11]
: Play button [8~10, 13, 14]
: Fast reverse button [9, 15]
: Fast forward button [9, 15]
: Reverse skip button [11, 14]
: Forward skip button [11, 14]
3. NEXT SELECTION button [12]
4. Direct play buttons
4. Direct play buttons
(DISC 1-DISC 6) [10, 12, 14]
5. Number buttons and +10 button [10, 12, 14]
6. DISC INTRO SCAN button [11]
7. RANDOM button [13]
8. REPEAT button [13]
9. MEMORY button [14, 15]
6. DISC INTRO SCAN button [11]
7. RANDOM button [13]
8. REPEAT button [13]
9. MEMORY button [14, 15]
10. CLEAR button [15]
RC-435C
Inserting the remote controller batteries
1. Remove the battery compartment cover by opening
it as shown in the illustration.
2. Insert two AA (R6- or UM-3)-size batteries into the bat-
tery compartment. Carefully follow the polarity dia-
gram (positive (+) and negative (–) symbols) inside the
battery compartment.
gram (positive (+) and negative (–) symbols) inside the
battery compartment.
3. After batteries are installed and seated correctly, re-
place the compartment cover.
Notes:
•
Do not mix new batteries with old batteries or differ-
ent kinds of batteries.
ent kinds of batteries.
•
To avoid corrosion, remove the batteries if the remote
controller is not to be used for a long time.
controller is not to be used for a long time.
•
Remove dead batteries immediately to avoid damage
from corrosion. If the remote controller doesn’t operate
smoothly, replace both the batteries at the same time.
from corrosion. If the remote controller doesn’t operate
smoothly, replace both the batteries at the same time.
•
The life of the batteries supplied is about six months
but this will vary depending on usage.
but this will vary depending on usage.
Using the remote controller
Point the remote controller toward the remote control
sensor.
sensor.
Notes:
•
Place the unit away from strong light such as direct
sunlight or inverted fluorescent light which can pre-
vent proper operation of the remote controller.
sunlight or inverted fluorescent light which can pre-
vent proper operation of the remote controller.
•
Using another remote controller of the same type in
the same room or using the unit near equipment which
uses infrared rays may cause operational interference.
the same room or using the unit near equipment which
uses infrared rays may cause operational interference.
•
Do not put any object such as a book on the remote
controller. The buttons of the remote controller may
be pressed by mistake and drain the batteries.
controller. The buttons of the remote controller may
be pressed by mistake and drain the batteries.
•
Make sure the audio rack doors do not have colored
glass. Placing the unit behind such doors may prevent
proper remote controller operation.
glass. Placing the unit behind such doors may prevent
proper remote controller operation.
•
If there is any obstacle between the remote controller
and the remote control sensor, the remote controller
will not operate.
and the remote control sensor, the remote controller
will not operate.
1
2
10
8
7
6
9
3
4
5
DISC 1
DISC 2
DISC 3
1
2
3
REPEAT
CLEAR
+10
0
DISC 4
DISC 5
DISC 6
4
5
6
7
8
9
MEMORY
NEXT SELECTION
RANDOM
DISC
INTRO SCAN
REMOTE CONTROLLER RC-435C
Insert the batteries into the remote controller
following the illustration below.
following the illustration below.
1
3
2
CDC-3.1
Remote control sensor
approx. 5 m
(16 feet)
(16 feet)
30°
30°
CDC-3.1_05-07
09/05/2000, 4:24 PM
6