Aethra avc500 ユーザーガイド

 

 

In these pages you can configure some system parameters. 

•  Local Information: 

If activated, shows information such as terminal name, ISDN number, and IP address on the monitor in graphical 
form  

•  Warning messages: 

If activated, allows visualization of “Bonding Recovery” messages 

•  Show logo when in a call: 

Enables/disables logo display during a call. Logo is customizable, default is Aethra S.p.A. 

•  Disable still picture: 

Disable transmission/receiving of “still images”. 

•  TFTP server: 

Disable or enable and configure TFTP server (to obtain server IP address, please contact your network 
administrator). If enabled,  still images can be sent and stored in a TFTP (Trivial File Transfer Protocol) server. These 
still images will be available for future use. 

•  Automatic screensaver: 

to enable/disable the automatic screensaver function, and to set its timeout 

•  XGA on screensaver: 

Enable/disable XGA loop function: “XGA IN” signal sent to “XGA OUT.” 
Two possible cases: 

1.  Active “XGA IN” signal: monitor shows XGA signal. 
2.  Inactive  “XGA IN” signal: no signals on monitor (“Stand By” mode). 

•  Numeric only remote control: 

Enable\Disable alphabetical digits only on the remote control 

•  ID code: 

In order to control more systems with only one remote control, you can assign to each system a numeric code (01 to 
99), and then consequently set the remote control. 

•  To configure the system: 

a. 

The system code appears in the page. 

b. 

Is possible modify or save the new code. 

•  To configure the remote control: 

1.  Press the “RED” and “GREEN” keys at the same time. 
2.  Wait for “Stand by” key stopping blinking. 
3.  Insert the numeric code (01 to 99). 

 

32