Aethra avc500 Mode D'Emploi
Control panel
In these pages you can configure some system parameters.
Display
• Local Information:
If activated, shows information such as terminal name, ISDN number, and IP address on the monitor in graphical
form
form
• Warning messages:
If activated, allows visualization of “Bonding Recovery” messages
• Show logo when in a call:
Enables/disables logo display during a call. Logo is customizable, default is Aethra S.p.A.
• Disable still picture:
Disable transmission/receiving of “still images”.
• TFTP server:
Disable or enable and configure TFTP server (to obtain server IP address, please contact your network
administrator). If enabled, still images can be sent and stored in a TFTP (Trivial File Transfer Protocol) server. These
still images will be available for future use.
administrator). If enabled, still images can be sent and stored in a TFTP (Trivial File Transfer Protocol) server. These
still images will be available for future use.
Screensaver
• Automatic screensaver:
to enable/disable the automatic screensaver function, and to set its timeout
• XGA on screensaver:
Enable/disable XGA loop function: “XGA IN” signal sent to “XGA OUT.”
Two possible cases:
Two possible cases:
1. Active “XGA IN” signal: monitor shows XGA signal.
2. Inactive “XGA IN” signal: no signals on monitor (“Stand By” mode).
2. Inactive “XGA IN” signal: no signals on monitor (“Stand By” mode).
Remote control
• Numeric only remote control:
Enable\Disable alphabetical digits only on the remote control
• ID code:
In order to control more systems with only one remote control, you can assign to each system a numeric code (01 to
99), and then consequently set the remote control.
99), and then consequently set the remote control.
• To configure the system:
a.
The system code appears in the page.
b.
Is possible modify or save the new code.
• To configure the remote control:
1. Press the “RED” and “GREEN” keys at the same time.
2. Wait for “Stand by” key stopping blinking.
3. Insert the numeric code (01 to 99).
2. Wait for “Stand by” key stopping blinking.
3. Insert the numeric code (01 to 99).
32