Ricoh AP400 ユーザーガイド
Appendix
120
7
Changing the password
Use the passwd command to change the remote maintenance password.
Important
❒ Be sure not to forget or lose the password.
Note
❒ The default password is “password”.
AAAA
Type “passwd”.
msh> passwd
BBBB
Type the current password.
Old password:
CCCC
Type the new password.
New password:
Note
❒ The password must consist of 3 to 8 alphanumeric characters and symbols.
Upper and lower case characters are considered unique. For example, R is
different from r.
different from r.
❒ The password is the same as that used in the configuration of the Network
Interface Board using a Web Browser and that used in the NIB Setup Tool.
If you change a password from telnet, the other passwords are also
changed.
If you change a password from telnet, the other passwords are also
changed.
DDDD
Type the new password once again.
Retype new password:
DNS
Use the "dns" command to configure or display DNS (Domain Name System)
settings.
settings.
❖
❖
❖
❖ View setting
The following command displays current DNS settings:
msh> dns
❖
❖
❖
❖ Using the DNS server obtained from the DHCP server
The following command enables/disables use the DNS server obtained from
the DHCP server:
the DHCP server:
msh> dns dhcp {valid | invalid}
• If you use the DNS server obtained from the DHCP server, select “valid”.
If not, select “invalid”.
If you set “valid”, the DNS server from the DHCP server is prioritized.
If you set “valid”, the DNS server from the DHCP server is prioritized.