Nikon 800 パンフレット

If your camera is version 1.0 it is recommended that you update the firmware
in your camera to 1.1 in order to benefit from improved operating
performance.

The entire package (Uploader software and new firmware for the camera) is
supplied in a single file, which is compressed for distribution over the Internet.
Before performing a firmware update, you must de-compress the files back to
their original format.

The principal changes to the camera firmware with the release of version 1.1
are in the form of the following improvements to product performance and
minor bug fixes (not listed):
1. Improvement in white balance control in fixed aperture mode

If you select AE Lock mode in manual white balance mode, the image
sometimes becomes green. This problem has been solved.

This utility will update the firmware in your COOLPIX 800 to version 1.1. It can
only be used if the version of the firmware in your COOLPIX 800 is version
1.0 and is not suitable for use with any other model of Coolpix camera. This
version of the firmware can only update NTSC cameras.

Your COOLPIX 800 could malfunction should any of the problems listed below
occur while the firmware is being upgraded. Please exercise all necessary
caution during the upgrade. The upgrade can be performed for you at a Nikon-
authorized service center in the event that you do not have the equipment
necessary to perform the upgrade, or are otherwise unsure that you would be
able to perform the upgrade yourself. Your COOLPIX 800 could malfunction
should any of the following occur during upgrade:

1. The camera turns off during the upgrade process
2. The data cable is disconnected
3. A problem occurs with the computer
4. The upgrade is performed in a place where there is excessive electrical

noise.

The camera could also malfunction if you make a forced exit from the uploader or
another application interferes with the uploader during the upgrade. Be sure to
exit any other applications before running the uploader software.