Lowrance lms-522c igps 操作ガイド

ページ / 252
39 
MMC or SD Card Memory Card Installation 
Your unit uses a MultiMedia Card to store information, such as sonar 
logs, custom maps, waypoints, trails and other GPS data. It can also 
use Secure Digital Cards (SD card) to store data. 
NOTE: 
Throughout this manual, we will use the term MMC, but just re-
member that your unit can use an MMC or SD card to store data. 
Both of these solid-state flash memory devices are about the size of a 
postage stamp. An SD card is slightly thicker than an MMC. As this 
manual went to press, MMCs were available in storage capacities of 8 
MB, 16 MB, 32 MB, 64 MB and 128 MB. SD cards were available with 
capacities of 8 MB, 16 MB, 32 MB, 64 MB, 128 MB, 256 MB and 1 GB. 
Additional MMC cards are available from LEI Extras; see ordering in-
formation inside the back cover of this manual. MMCs and SD cards 
are also available at many camera and consumer electronics stores. 
The MMC slot is located in a compartment on the front of the case. The 
compartment door is located at the lower right corner. The following 
figure shows a close-up with the door opened. 
 
Memory card compartment with a 16 MB MMC card installed. 
To remove an MMC 
1. Open the card compartment door by unscrewing the thumb screw. 
The screw should only be finger tight. If it was over-tightened, use a 
thumbnail, a coin or a screwdriver to open the door. 
2. Press a finger against the label of the MMC and drag it from the slot. 
3. Close the compartment door and fasten the thumb screw finger tight. 
 
 
Insert card face up, 
this way 
Thumb 
screw 
MMC groove for card removal