Adaptec rs ユーザーガイド
2-7
Unpacking and Initial Setup
Port Bypass Card Insertion
The port bypass cards are located on the rear of the Storage Array (see Figure 3-
1).
1).
Installing a port bypass card
1.
Hold the port bypass card by it’s handle at 90
o
to the rear of the Storage
Array.
2.
Slide the port bypass card into the port bypass card slot.
3.
Using the two panel fasteners on the port bypass card secure it in place.
Rackmounting a RAIDStation7 Fibre Channel Storage Array
The RAIDStation7 Fibre Channel Storage Array rack mount shelf can be
installed in a standard 19 inch equipment rack. To ensure correct functionality of
the rack mounted shelf the guidelines set out previously in this chapter regarding
environmental, mechanical and electrical recommendations must be followed.
installed in a standard 19 inch equipment rack. To ensure correct functionality of
the rack mounted shelf the guidelines set out previously in this chapter regarding
environmental, mechanical and electrical recommendations must be followed.
NOTE: When installing or removing a rack mount shelf, remove all
power supplies and disk drives. It is recommended that you work
with at least one other person when installing a disk shelf. This is
necessary to prevent personal injury and damage to the shelf.
power supplies and disk drives. It is recommended that you work
with at least one other person when installing a disk shelf. This is
necessary to prevent personal injury and damage to the shelf.
Installing the Storage Array in an equipment rack
1.
On each of the front mounting rails of your equipment rack cabinet, select
four holes that are spaced appropriately for the mounting holes on the Stor-
age Array.
four holes that are spaced appropriately for the mounting holes on the Stor-
age Array.
2.
Align the holes on the flanges of the Storage Array with the holes you have
chosen in (1) above.
chosen in (1) above.
3.
Insert two of the screws provided with the Storage Array into the holes on
the bottom flange of the Array and the mounting holes of the equipment
rack.
the bottom flange of the Array and the mounting holes of the equipment
rack.
4.
Insert the screws in the top flanges.
5.
Ground per Figure 2-1.