Hisense kf-2302gwe ユーザーガイド
8
NOTE
(1)Lead the tubing and drain hose through the wall,
allowing sufficient length for connection. then
bend the tubing using a tube bender to make the
attachment.(Fig.23a)
bend the tubing using a tube bender to make the
attachment.(Fig.23a)
(2)Switch the drain hose and drain cap.
Switch the drain hose and drain cap
(a)Locate the drain hose and the drain cap.
(Fig.23b)
(b)Remove the drain hose on the right side by
pushing and turning the hose connector counter-
clockwise to release it. (Fig.23b)
clockwise to release it. (Fig.23b)
(c)Apply moderate force to pull off the drain cap
on the left side.(If you cannot pull it off by
hand, use a long -nose pliers.)
(d)Reattech the drain hose to the left side and
the drain cap to the right side. (Fig.23c)
drain hose
While pushing the drain connector, turn it
While pushing the drain connector, turn it
clockwise until it clicks. Slip the connector onto
the outlet firmly.
Drain cap
Use a Phillips screwdriver to push the drain cap
in firmly. (if it is difficult to push in, wet the
cap with water first.)
in firmly. (if it is difficult to push in, wet the
cap with water first.)
For tubing. choose either the right or left tubing
direction
and follow the steps below. Also, extend the
support on
direction
and follow the steps below. Also, extend the
support on
Right-side tubing
(3)Carefully bend the tubing (if necessary) to run
along
the wall in the direction of the outdoor unit
and then tape as far as the fittings. The drain
and then tape as far as the fittings. The drain
hose should come straight down the wall to a
,
point where water run off won t stain the wall.
(4)Connect the refrigerant tubing to the outdoor
unit.
(After performing a leak test on the connecting
(After performing a leak test on the connecting
part, insulate it with the tubing insulation.
(Fig.22)Also, refer to Section 5-4. Connecting
(Fig.22)Also, refer to Section 5-4. Connecting
Tubing between Indoor and Outdoor Units.
(5)Assemble the refrigerant tubing, drain hose,
and inter- unit wiring as shown in fig.22.
(1) Shape the refrigerant tubing so that it can easily go
into the wall hole. (Fig.21a)
into the wall hole. (Fig.21a)
(2) Push the wiring, refrigerant tubing, and drain hose
through the hole in the wall. Adjust the indoor unit so
it is securely seated on the rear panel. (Fig.21b)
through the hole in the wall. Adjust the indoor unit so
it is securely seated on the rear panel. (Fig.21b)
Left -side-tubing
Fig.21b
Insulation
Rear panel
Wide tube
Narrow tube
Bent part
Hole in wall
Fig.22
Fig.23a
Drain cap
Drain hose
Fig.23b