Hisense kf-2302gwe User Guide

8

NOTE

(1)Lead the tubing and drain hose through the wall, 

allowing  sufficient  length  for  connection.  then 
bend the tubing using a tube bender to make the 
attachment.(Fig.23a)

(2)Switch the drain hose and drain cap.

    

   Switch the drain hose and drain cap

(a)Locate the drain hose and the drain cap.

    (Fig.23b)

(b)Remove  the  drain  hose  on  the  right  side  by 

pushing  and  turning  the  hose  connector  counter-
clockwise to release it. (Fig.23b)

(c)Apply  moderate  force  to  pull  off  the  drain  cap 

on  the  left  side.(If  you  cannot  pull  it  off  by 

hand, use a long -nose pliers.)

(d)Reattech  the  drain  hose  to  the  left  side  and 

the drain cap to the right side. (Fig.23c)

drain hose
While  pushing  the  drain  connector,  turn  it 

clockwise until it clicks. Slip the connector onto 

the outlet firmly.

Use  a  Phillips  screwdriver  to  push  the  drain  cap 
in firmly. (if it is difficult to push in, wet the 
cap with water first.)

For tubing. choose either the right or left tubing 
direction
and  follow  the  steps  below.  Also,  extend  the 
support on

(3)Carefully bend the tubing (if necessary) to run 

along

the  wall  in  the  direction  of  the  outdoor  unit 
and then tape as far as the fittings. The drain 

hose  should  come  straight  down  the  wall  to  a 

,

point where water run off won t stain the wall.

(4)Connect  the  refrigerant  tubing  to  the  outdoor 

unit.
(After performing a leak test on the connecting 

part,  insulate  it  with  the  tubing  insulation. 
(Fig.22)Also,  refer  to  Section  5-4.  Connecting 

Tubing between Indoor and Outdoor Units.

(5)Assemble  the  refrigerant  tubing,  drain  hose, 

and inter- unit wiring as shown in fig.22.

(1)  Shape the refrigerant tubing so that it can easily go
      into the wall hole. (Fig.21a)

(2) Push the wiring, refrigerant tubing, and drain hose
     through the hole in the wall. Adjust the indoor unit so
     it is securely  seated on the rear panel. (Fig.21b)

Insulation

Rear panel

Wide tube

Narrow tube

Bent part

Hole in wall

Drain cap

Drain hose