3com S7906E 参照ガイド
1-24
Parameters
remote-system: IPv6 address or host name of the remote system. An IPv6 address can be up to 46
characters; a host name is a string of 1 to 20 characters.
-i interface-type interface-number: Specifies the outbound interface by interface type and interface
number. The outbound interface is required when the destination address is a local link address.
port-number: TCP port number assigned to Telnet service on the remote system, in the range 0 to
65535 and defaults to 23.
Description
Use the telnet ipv6 command to telnet to a remote device for remote management. You can terminate
a Telnet connection by pressing <Ctrl + K>.
Examples
# Telnet to the device with IPv6 address 3001::1.
<Sysname> telnet ipv6 3001::1
Trying 3001::1 ...
Press CTRL+K to abort
Connected to 3001::1 ...
******************************************************************************
* Copyright (c) 2004-2009 3Com Corp. and its licensors. All rights reserved. *
* This software is protected by copyright law and international treaties. *
* Without the prior written permission of 3Com Corporation and its licensors,*
* any reproduction republication, redistribution, decompiling, reverse *
* engineering is strictly prohibited. Any unauthorized use of this software *
* or any portion of it may result in severe civil and criminal penalties, and*
* will be prosecuted to the maximum extent possible under the applicable law.*
******************************************************************************
<Sysname>
telnet client source
Syntax
telnet client source { ip ip-address | interface interface-type interface-number }
undo telnet client source
View
System view
Default Level
2: System level
Parameters
None