Infocus LP500 参照ガイド
30
U
s
i
n
g
t
h
e
P
r
o
j
e
c
t
o
r
Zoom
This allows you to enter zoom mode without using the remote.
Highlight
Highlight
Zoom
, press
menu/select
,
use the left or right arrow
buttons to turn zoom mode on, then press
menu/select
. Exit the
menus to use the zoom feature. The zoom icon appears in the
lower right corner. Use the right mouse button to zoom in and
use the left mouse button to zoom out. Use the keypad naviga-
tion buttons on the keypad to pan the zoomed image. To exit
zoom mode, either turn the feature off in the Image menu or
press the
lower right corner. Use the right mouse button to zoom in and
use the left mouse button to zoom out. Use the keypad naviga-
tion buttons on the keypad to pan the zoomed image. To exit
zoom mode, either turn the feature off in the Image menu or
press the
zoom mode
button on the remote.
Auto Image
The projector automatically adjusts tracking, signal synchroniza-
tion and vertical and horizontal position for most computers. If
you want to adjust these features manually, you must turn off
tion and vertical and horizontal position for most computers. If
you want to adjust these features manually, you must turn off
Auto image
first.
Highlight
Auto image
,
press
menu/select
,
then press the left or
right arrow buttons to turn this feature off and on.
Manual Sync
NOTE: The Manual Sync,
Manual Tracking, Horizontal
Position and Vertical Position
options are available only for
analog computer sources. The
projector sets these options
automatically for digital computer
and video sources, with no manual
override.
The projector adjusts signal synchronization automatically for
most computers. But if the projected computer image looks fuzzy
or streaked, try turning
most computers. But if the projected computer image looks fuzzy
or streaked, try turning
Auto image
off then back on again. If the
image still looks bad, try adjusting the signal synchronization
manually:
manually:
1
Turn Auto Image off.
2
Highlight Manual sync, press
menu/select,
use the arrow but-
tons to adjust Manual sync until the image is sharp and free of
streaks, then press
streaks, then press
menu/select
.
Manual Tracking
The projector adjusts tracking automatically to match the video
signal from your computer. However, if the display shows
evenly spaced, fuzzy, vertical lines or if the projected image is too
wide or too narrow for the screen, try turning
signal from your computer. However, if the display shows
evenly spaced, fuzzy, vertical lines or if the projected image is too
wide or too narrow for the screen, try turning
Auto Image
off then
back on again. If the image is still bad, try adjusting the tracking
manually:
manually:
1
Turn Auto image off.
2
Highlight Manual tracking, press
menu/select,
use the arrow
buttons to adjust Manual tracking until the fuzzy vertical bars
are gone, then press
are gone, then press
menu/select
.