Infocus LP500 参照ガイド
31
Horizontal Position
Follow these steps to manually adjust the horizontal position:
1
Turn Auto image off.
2
Highlight Horizontal position, press
menu/select,
use the
arrow buttons to adjust the Horizontal position, then press
menu/select
.
Positioning adjustments are saved when you turn off the projec-
tor.
tor.
Vertical Position
Follow these steps to manually adjust the vertical position.
1
Turn Auto image off.
2
Highlight Vertical position, press
menu/select,
use the arrow
buttons to adjust the Vertical position, then press
menu/select
.
Positioning adjustments are saved when you turn off the projec-
tor.
tor.
Overscan (video sources only)
This option crops all the edges of the image to remove noise gen-
erated on the edges by your source. This option is available for
video sources only.
erated on the edges by your source. This option is available for
video sources only.
Video Standard (video sources only)
When Video is set to Auto, the projector attempts to pick the
video standard (NTSC, NTSC 4.43, PAL, PAL-M, PAL-N, PAL 60
or SECAM) automatically based on the input signal it receives.
(The video standard options may vary depending on your region
of the world.) If the projector is unable to detect the correct stan-
dard, the colors might not look right or the image might appear
“torn.” If this happens, manually select a video standard.
Highlight
video standard (NTSC, NTSC 4.43, PAL, PAL-M, PAL-N, PAL 60
or SECAM) automatically based on the input signal it receives.
(The video standard options may vary depending on your region
of the world.) If the projector is unable to detect the correct stan-
dard, the colors might not look right or the image might appear
“torn.” If this happens, manually select a video standard.
Highlight
Video standard
, press
menu/select
,
use the left or right
arrows to cycle through the options, then press
menu/select
to
select.