Infocus XS1 参照ガイド

ページ / 61
Maintenance
53
Replacing the lamp
WARNING
Hg - Lamp contains mercury. Manage in accordance with local 
disposal laws. See www.lamprecycle.org 
To reduce the risk of electrical shock, always turn the projector off and disconnect the 
power cord before changing the lamp.   
To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes 
before replacing the lamp.
To reduce the risk of injuries to fingers and damage to internal components, use caution 
when removing lamp glass that has shattered into sharp pieces.
To reduce the risk of injuries to fingers and/or compromising image quality by touching 
the lens, do not touch the empty lamp compartment when the lamp is removed.
To assure optimal performance from the projector, it is recommended that you purchase 
the InFocus projector lamp for lamp replacement.
If lamp replacement is performed while the projector is suspended upside-down from the 
ceiling, make sure that no one is underneath the lamp socket to avoid any possible injury 
or damage to the human eyes caused by fractured lamp.
1.
Turn the power off and disconnect the projector from the wall socket.
 
If the 
lamp is hot, avoid burns by waiting for approximately 45 minutes until the lamp 
has cooled.
2.
Use a coin to turn the screw 
counterclockwise until the lamp cover 
loosens.
3.
Remove the lamp cover from the 
projector.
WARNING
Do not turn the power on with the lamp cover 
removed.
Do not insert your fingers between the lamp and 
the projector. The sharp edges inside the 
projector may cause injuries.