ICOM ic-207h 取り扱いマニュアル

11

46

■ Programming a DTMF code

DTMF codes are used for autopatching, accessing repeaters,
controlling other equipment, etc. The transceiver has 14
DTMF memory channels (d0– d9, dA–dd) for storage of often-
used DTMF codes of up to 16 digits.

NOTE: DTMF memory channels are commonly used for
both bands. Therefore, programming each band is not
necessary.

➀

Push 

for one sec. and “d” appears in place of the

100 MHz digit as shown below.

➁

Push [SET] to enter the programming condition.

➂

Rotate the tuning dial to select the desired channel.

➃

Push [SET] or [MONI] to select the cursor.

➄

Rotate the dial to select a digit.

• “E” stands for “M” and “F” stands for “#.”

➅

Repeat steps 

➃ and ➄ until the last digit is entered.

• The S/RF indicator shows the digit group. The indication in-

creases every 6 digits.

• Select “–” to clear the remaining digits when programming over a

previously used memory channel.

➆

Push [V/MHz] exit the programming condition.

■ Clearing the DTMF memory

➀

Push 

for 1 sec. to turn the DTMF memory encoder

ON.

➁

Push [SET] to enter the programming condition.

➂

Rotate the tuning dial to select the desired channel.

➃

Push [SET] to activate the 1st digit.

➄

Rotate the tuning dial to select “–” and clear the memory
channel contents.

➅

Push the tuning dial to exit the programming condition.

“d” appears in place of 
the 100 MHz digit.