Eos -100t1rb ユーザーズマニュアル

Setting a Unique ID:
To give your Base Station and Speakers/Receivers a Unique ID do the following:

1. Disconnect the power supply from the Base Station
2. Using the Volume Control Switch, turn off all power to the Wireless Speakers/Re-

ceivers that you wish to link.

3. Reconnect the power supply to the Base Station
4. Press and hold the “LINK” button on the rear of the Base Station for 3 seconds until

all four “Wireless Speaker Link LEDs” on the Base Station start blinking and then

release button.

Note: all four “Wireless Speaker Link LEDs” on the Base Station will blink while in “Link

Mode”

5. Turn on the Wireless Speakers/Receivers that you wish to link to this Base Station

within 60 seconds of pressing the “LINK” button.

Note: to link additional speakers once a unique ID has been set, refer to the “Adding a

Speaker to a System with a Unique ID” section below.

Adding a Speaker to a System with a Unique ID:
Once a unique ID is set on your Base Station, you will need to do the following to link ad-

ditional speakers to your Base Station: Please note - this procedure is only necessary if you

have set a unique ID for your Base Station.

1. Disconnect the power supply from the Base Station
2. Using the Volume Control Switch, turn power to the Wireless Speakers/Receivers

that you wish to link.

3. Reconnect the power supply from the Base Station
4. Press and hold the “LINK” button on the rear of the Base Station for 8 seconds until

only the first “Wireless Speaker Link LED” on the Base Station starts blinking and

then release button.

Note: When Link button is pressed and held, the “Wireless Speaker Link LEDs” on the

Base Station will blink slowly for a few seconds and then go to a fast blink (fast blinking

indicates the Base Station is in “Add a Speaker Mode”)

5. Turn on the Wireless Speaker/Receivers that you wish to link to this Base Station

one at a time within 60 seconds of pressing the “LINK” button.

Using Your Eos System