Eos -100t1rb ユーザーズマニュアル

Resetting the ID to Default:
To reset the Base Station and Speaker/Receiver’s ID back to the factory default, do the 

following:

1.  Disconnect the power supply from the Base Station 
2.  Using the Volume Control Switch, turn off all power to the Wireless Speakers/Receivers.
3.  While pressing and holding the “LINK” button on the rear of the Base Station reconnect

the power supply from the Base Station. Hold the link button for about 3 seconds. 

4.  Release “LINK” button
Note: all four “Wireless Speaker Link LEDs” on the Base Station will blink while in “Reset Mode”
5.  Turn on the Wireless Speakers/Receivers within 60 seconds of releasing the “LINK” button.

to link with your Base Station or any other Base Station with the factory default ID in the vicinity.
Range Extender:
The Range Extender Switch, located on the back of the Base Station, allows you to increase 

the effective range of the Eos Wireless System.  Use this button only if you are having 

difficulty linking up your Wireless Speakers/Receivers.  

About “Range Extender” - To maintain a solid, interference free link,

the Eos system incorporates an advanced proprietary error correction 

scheme.  Error correction is done by creating a slight delay between 

the transmitter and Wireless Speaker. Using this delay, Eos can confirm 

that the audio packets arrive at the Wireless Speaker/receiver. If the 

audio packet is not received, the Eos Base Station can resend it. Eos’ 

default delay (Range Extender Off) is 20ms. 

Turning on the Range Extender Switch increases the delay to 64ms. The increased delay 

allows Eos to resend more audio packets due to distance from the transmitter or ambient 

interference.