LG LD-1481W4 オーナーマニュアル

1.  If the end of drain hose does not fit to the 

drain line, use a rubber coupling (not 

supplied) that is resistant to heat and 

detergent.

2.  This should be available from a plumbing 

shop or a hardware store.

3.  There are two typical connections as shown 

in Figure A, B.

The S trap spigot must be drilled out cleanly 

and free of obstruction to its maximum 

internal diameter, if used for drainage.

To prevent siphoning, one of the following 

methods must be used:

Check the waste spigot when initially installing. 

An “OE” error can occur when the waste spigot 

below the sink is not drilled out properly.  

Please ensure the waste spigot connection to this 

drain hose has been completely drilled out before 

connecting and securing.

  When the drain hose is connected to a sink S 

trap or waste disposal unit, the hose must be 

looped up to the underside of the bench top 

and secured.

Extend drain hose as shown below.

Drain hose

extension kit

  When the drain hose is connected to a 

separate standpipe, it is essential that an 

airtight connection be made. 

Refer to Fig.B

• When you connect or extend drain hose, 

(Bends should have a 40mm radius.) 

Use the drain hose extension kit appropriately.