KitchenAid 27'' Slow Cook Warming Drawer, Architect® Series II インストールガイド

Warming drawer can be installed as an indoor single or double 
installation or installed under a single oven. Two warming drawers 
under a single oven are shown.

NOTE: The warming drawer cannot be leveled after being 
installed.

For outdoor installation, follow the cutout dimensions above. 
Install the outdoor warming drawer in a permanent fixture.

If you plan to install a custom wood panel to match your 
cabinets, we recommend consulting a qualified cabinetmaker or 
carpenter. The back of the wood panel must be sealed to avoid 
moisture damage.

IMPORTANT: The warming drawer must be electrically grounded 
in accordance with local codes and ordinances, or in the absence 
of local codes, with the National Electrical Code, ANSI/NFPA 70 
or Canadian Electrical Code, CSA C22.1.

If codes permit and a separate ground wire is used, it is 
recommended that a qualified electrical installer determine that 
the ground path is adequate.

A copy of the above code standards can be obtained from:

National Fire Protection Association

1 Batterymarch Park

Quincy, MA 02169-7471

CSA International

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

■

A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is 
required. A time-delay fuse or circuit breaker is also 
recommended. It is recommended that a separate circuit 
serving only this warming drawer be provided.

■

The model/serial rating plate is located above the left-hand 
side receiving slide. The warming drawer must be removed to 
view the model/serial rating plate. See the following 
illustration.

24" (61 cm)

22

¹⁄₂" (57.1 cm)

24" (61 cm)

27" (68.6 cm)

25

¹⁄₂" (64.8 cm)

27" (68.6 cm)

30" (76.2 cm)

28

¹⁄₂" (72.4 cm)

30" (76.2 cm)

B

A

A