KitchenAid 27'' Slow Cook Warming Drawer, Architect® Series II インストールガイド

1. Turn off power supply. Using 2 or more people, move 

warming drawer close to its final location. Remove and 
discard shipping materials, tape, and film from the warming 
drawer. Remove and set aside racks and other parts from 
inside warming drawer. 

2. Check that the warming drawer Temperature control knob is 

set to the OFF position.

3. Support the warming drawer on a sturdy surface level with 

the cutout opening.

4. Plug the power supply cord into the grounded 3 prong outlet.

5. Slide the warming drawer over halfway into the cutout 

opening.

6. Open warming drawer and slowly push against the front 

panel to slide the drawer completely into the cabinet until the 
flanges on the front panel meet the cabinet face.

7. Use the two #8-18 x 

⁵⁄₈" screws provided to secure the 

warming drawer frame to the cabinet.

1. Check that all parts are now installed. If there is an extra part, 

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. For warming drawer use and cleaning, read the Use and Care 

Guide.

5. Turn the Temperature control knob to HI. The light should 

illuminate.

■

Household fuse is intact and tight; or circuit breaker has not 
tripped.

■

Warming drawer is plugged in, and electrical supply is 
connected.

Please reference the “Assistance or Service” section of the Use 
and Care Guide or contact the dealer from whom you purchased 
your warming drawer.

⁵⁄₈" screws

A