Nikon SB-N10 ユーザーズマニュアル
24
En
❚❚
Using TTL Flash Control with the J1, J2, J3, and S1
Follow the steps below to take pictures in TTL fl ash control mode.
1
Adjust camera settings.
Adjust camera settings as follows.
• Shooting mode: Choose programmed
Adjust camera settings as follows.
• Shooting mode: Choose programmed
auto (P), shutter-priority auto (S), ap-
erture-priority auto (A), or manual (M).
erture-priority auto (A), or manual (M).
• Flash mode: Choose a setting that disables red-eye reduc-
tion and ensures that the fl ash will fi re with every shot.
2
Set the fl ash unit to TTL.
Rotate the mode dial to TTL and
confi rm that the fl ash-ready lamp is
lit blue. If it is not, keep the target-
ing lamp button pressed until the
lamp lights blue (about three sec-
onds) to show that fl ash-compen-
sation support is disabled (
Rotate the mode dial to TTL and
confi rm that the fl ash-ready lamp is
lit blue. If it is not, keep the target-
ing lamp button pressed until the
lamp lights blue (about three sec-
onds) to show that fl ash-compen-
sation support is disabled (
0
5).
3
Take pictures.