Canon LV-7380 マニュアル
38
4. Convenient Features
Lamp Mode and Energy-Saving Effect
Selecting [Quiet] for Lamp mode will help you to reduce CO
2
emissions from the projector.
The Lamp mode enables you to select two brightness modes of the lamp: Normal and Quiet modes. The lamp life
can be extended by using the Quiet mode.
can be extended by using the Quiet mode.
Lamp Mode
Description
Status of LAMP indicator
Normal Mode
This is the default setting (100%
Brightness).
Brightness).
Off
Quiet Mode
Select this mode to increase the
lamp life (LV-7385/LV-8310/LV-8215:
approx.75% Brightness/LV-7380/LV-
7285/LV-7280: approx.80% Bright-
ness).
lamp life (LV-7385/LV-8310/LV-8215:
approx.75% Brightness/LV-7380/LV-
7285/LV-7280: approx.80% Bright-
ness).
Steady Green
light
Changing Lamp Mode
To change the [Lamp mode] from [Normal] to [Quiet], do the following:
1. Press the MENU button on the remote control to display the menu.
2. Select [Setup]
2. Select [Setup]
→ [General] → [Lamp mode].
3. Press the ENTER button to display the Lamp mode menu.
4. Press the button to select [Quiet] and press the OK button.
5. Press the OK button to close the menu.
4. Press the button to select [Quiet] and press the OK button.
5. Press the OK button to close the menu.
NOTE:
• The projector has the Eco message function that will show the status of Quiet mode on screen. Select [Setup] → [Menu] → [Eco
.
• The lamp life remaining and lamp hours used can be checked in [Usage time]. Select [Information] → [Usage time]. See page
.
• The projector will only operate in the [Quiet] mode for 90 seconds immediately after the lamp is turned on.
The lamp condition will not be affected even when [Lamp mode] is changed.
• If there is no signal for about one minute, the projector will display a blue, black or logo background (depending on setting)
and go into [Quiet].
The projector will return to the [Normal] mode once a signal is accepted.
• If the projector is overheated in Normal mode, there may be a case where the Lamp mode automatically changes to Quiet
mode to protect the projector. This is called “forced cooling operation”. When the projector is in a forced cooling operation,
the picture brightness decreases. When the projector comes back to normal temperature, the Lamp mode returns to Normal
mode.
Thermometer symbol [ ] indicates the lamp mode is automatically set to a forced cooling operation because the internal
temperature is too high. In this condition, changing [Lamp mode] setting in the menu will not affect the actual lamp mode
and the LAMP indicator lights green.