Canon REALiS WUX10 Mark II D ユーザーズマニュアル
125
Maintenance
Appendix
Replacing the Lamp
When the time of use of the lamp exceeds the certain amount of time, the following mes-
sage (two types) is displayed for 10 seconds every time the projector is turned on.
sage (two types) is displayed for 10 seconds every time the projector is turned on.
1,800 - less than 2,000 hours
• After this screen has been displayed for 10 seconds and disappeared, all buttons
become operable.
• This message will not be displayed again if you select [Cancel] in response to the mes-
sage "Do you want to display this message again?".
Over 2,000 hours
• After this screen has been displayed for 10 seconds and disappeared, all buttons
become operable.
• You can check the time of use of the lamp in [Lamp counter] in the [System settings]
menu (
).
■About the Replacing Lamp
This projector uses the following lamp.
Lamp type No.RS-LP04
Lamp type No.RS-LP04
• Be sure to use the specified lamp.
• A lamp can be ordered from your dealer.
• When replacing the lamp, turn off the projector, wait until the cooling fan stops, disconnect the
• A lamp can be ordered from your dealer.
• When replacing the lamp, turn off the projector, wait until the cooling fan stops, disconnect the
power plug from the AC outlet, and let the projector stand for at least 1 hour. Otherwise, you
may get burned because the main unit is very hot immediately after the projector is turned off.
may get burned because the main unit is very hot immediately after the projector is turned off.
• Do not touch the inner glass surface when you replace the lamp. Otherwise, the projector 's
performance may degrade.
• Make sure to handle the lamp carefully and correctly since it may explode if it is scratched or
• Do not remove screws unless specified.
Prepare the new lamp when this screen is dis-
played.
• Only [<], [>], the OK button, and the POWER
played.
• Only [<], [>], the OK button, and the POWER
button are available while this screen is dis-
played.
played.
• When you press the POWER button, "Push
POWER button again to turn off power." mes-
sage appears.
sage appears.
Replace the lamp by referring to the procedure
on page
on page
when this screen is displayed.
• Only the POWER button is available while this
screen is displayed.
• When you press the POWER button, "Push
POWER button again to turn off the power."
message appears.
message appears.
Caution