Canon REALiS WUX10 Mark II D ユーザーズマニュアル

47

Proje

cti

ng

 an 
Im

age 

The auto setup function automatically makes the following settings and adjustments.

Use the auto setup function when:
• You turned the power on and the countdown sequence was completed.
• You changed the position or angle of the projector during the projection process.

Setting image input signal (Auto input)

Focusing (Auto focus)

Keystone correction (Auto keystone)

Screen color correction (Auto screen color correction)

• The auto screen color correction is disabled at the factory. To enable the auto screen color 

correction when performing the auto setup, select the function in menu. (

• You cannot set a digital PC signal or an AV equipment signal ([Digital PC] and [HDMI]) 

with the auto setup function. Select the appropriate signal by pressing the INPUT button. 
(

• When "No signal" message appears, press the INPUT button to select an appropriate 

input signal. (

)

• If focusing, keystone distortion and/or screen color correction have not been performed 

properly, manually adjust them. (Adjusting the focus: 

, Correcting keystone distortion: 

 and Correcting the screen color: 

• If you select [16:9 D. image shift] or [4:3 D. image shift] for [Screen aspect], [Auto setup] 

will be disabled and the following screen appears.

• When you press the INPUT button and then the AUTO SET button, only the input signal 

type is set.

• When you press the FOCUS button and then the AUTO SET button, only the focus is 

adjusted. If you select [16:9 D. image shift] or [4:3 D. image shift] for [Screen aspect], the 
auto focus function will be disabled.

• When you press the D.SHIFT/KEYSTONE button and then the AUTO SET button, only the 

keystone distortion is adjusted. If you select [16:9 D. image shift] or [4:3 D. image shift] for 
[Screen aspect], the keystone adjustment will be disabled.
The keystone adjustment is not performed under the some other conditions. For the 
details, refer to the page 

.