Epson Система команд EPSON ESC/P2 (Часть 2. Рекомендованные операции) 機能

Set the Printing Area        R-5

The method of setting the printing area differs between ESC/P 2 and former

ESC/P levels. Both methods are described in the following sections.

With ESC/P 2, the following commands allow for improved page layout control:

•

 

ESC ( U

Set unit

This command sets the unit for horizontal and vertical movement and

measurement. You can use this command to set the unit as small as 1/360

inch, allowing for precise page layout measurement.

•

 

ESC ( C

Set page length

The page length is based on the unit set with the ESC ( U command.

•

 

ESC ( c

Set page format

Based on the unit in ESC ( U, you can use this command to set the top and

bottom margins. Because you can now set a top margin, the settings you

make for the page actually match the physical page.

Because you can set the top and bottom margins for single-sheet paper, you

can handle single-sheets the same as continuous paper.

Manually fed single sheets are now treated the same as paper fed from a cut-

sheet feeder (cut-sheet feeder mode has been eliminated).

Set the print area as follows:

1. Set the left and right margins.

2. Set the page length.

3. Set the top and bottom margins 

ESC/P 2 printers

Set the bottom margin only

Non-ESC/P 2 printers

(continuous paper only)