Olympus e-3 入門マニュアル

60

EN

You can reduce the amount of camera shake that easily occurs when shooting in low light 
situations or shooting with high magnification.

Image stabilizer is off.

I.S. 1 Image stabilizer is on.
I.S. 2 This is used when panning in the horizontal direction to achieve a blurred background. 

The horizontal image stabilizer is turned off, and only the vertical image stabilizer is 
activated.

Press and release the o button, and then use the 
dial to make the setting.

You can hold down the o button during live view to see 
the effect of the image stabilizer on the monitor. While in 
that position, you can press the shutter button fully to 
take a picture.
• When [IMAGE STABILIZER] is set to [OFF], pressing 

and holding the o button activates the image 
stabilizer ([I.S. 1]).

• Either releasing the o button or holding down the o 

button for several seconds turns off the image 
stabilizer.

x

• The image stabilizer cannot correct excessive camera 

shake or camera shake that occurs when the shutter speed is set to the slowest speed. In 
these cases, it is recommended that you use a tripod.

• When using a tripod, set [IMAGE STABILIZER] to [OFF].
• When using a lens with an image stabilization function, turn off the image stabilization 

function of either the lens or the camera.

• Turning off the camera initializes the image stabilizer function. The camera will vibrate for this 

operation, but this is not a malfunction.

• A  red  H displayed on the monitor indicates the failure of the image stabilizer function. If you 

take a picture as is, the composition may be off. Consult your Olympus Authorized Service 
Center.

: OFF
: I.S. 1
: I.S. 2

o

 button

j

k

Green: Image stabilizer active
Red : Image stabilizer failure

38

38

s0011_e_00_0_unified.book  Page 60  Wednesday, September 12, 2007  4:46 PM