Netgear WC7520 - ProSafe 20-AP Wireless Controller 参照マニュアル
154
10
10.
Managing Stacking and Redundancy
This chapter includes the following sections:
Manage Stacking
The wireless controller supports stacking of up to three units for management of up to 150
access points through purchased licensing (see
access points through purchased licensing (see
on page 18). One wireless
controller functions as the primary controller (also known as the master), and the other two
wireless controllers function as secondary controllers (also known as slaves).
wireless controllers function as secondary controllers (also known as slaves).
The following figure shows a stacked configuration that is licensed to manage up to
120 access points:
120 access points:
•
Two controllers (
1
and
2
) each support up to 50 access points.
•
One controller (
3
) supports up to 20 access points.
Figure 82.
The wireless controllers that you intend to make members of the stack need to be connected
over a wired connection. A switch or router can be located between the wireless controllers
that are part of a stack.
over a wired connection. A switch or router can be located between the wireless controllers
that are part of a stack.
You configure the primary and secondary controllers individually, enable stacking on all
controllers, and then synchronize their access point configurations with the primary
controllers, and then synchronize their access point configurations with the primary
1
2
3