Netgear XCM8810 - 8800 SERIES 10-SLOT CHASSIS SWITCH ユーザーズマニュアル

on page 133 for the maximum number of 

links, selected and standby, per LACP.

Additionally, the following rules apply to load sharing on all switches:

The ports in the LAG do not need to be contiguous.

A LAG that spans multiple modules must use ports that have the same maximum 

bandwidth capability, with one exception—you can mix media type on 1 Gbps ports.

On both ingress and egress direction on NETGEAR 8800 series switches, when you 

configure an ACL to a LAG group, you must configure each of the member ports 
exclusively. 

Configuring Switch Load Sharing

on page 131 for specific 

information on load sharing for each specific device.

To set up a switch for load sharing, or link aggregation, among ports, you must create a 
load-sharing group of ports, also known as a link aggregation group (LAG). The first port in 
the load-sharing group is configured to be the master logical port. This is the reference port 
used in configuration commands and serves as the LAG group ID. It can be thought of as the 
logical port representing the entire port group.

All the ports in a load-sharing group must have the same exact configuration, including 
autonegotiation, duplex setting, and so on. All the ports in a load-sharing group must also be 
of the same bandwidth class.

The following sections describe common load sharing configuration tasks:

To define a load-sharing group, or LAG, you assign a group of ports to a single, logical port 
number. To enable or disable a load-sharing group, use the following commands: