Netgear XCM8810 - 8800 SERIES 10-SLOT CHASSIS SWITCH ユーザーズマニュアル

To display information on all the PVLANs configured on a switch, use the following command:

show private-vlan

To display information about a single PVLANs, use the following command:

show {private-vlan} <name>

To display information about a network or subscriber VLAN, use the following command:

show vlan {detail {ipv4 | ipv6} | <vlan_name> {ipv4 | ipv6} | virtual-router 

<vr-router> | <vlan_name> stpd | security}

The following flags provide PVLAN specific information:

s flag—identifies a network VLAN port that the system added to a subscriber VLAN. All 

subscriber VLANs contain network VLAN ports that are marked with the s flag.

L flag—identifies a subscriber VLAN port that is configured as a loopback port. 

t flag—identifies a tagged network VLAN port on which tag translation is enabled. The t 

flag only appears in the 

show vlan

 display for network VLANs.

e flag—identifies a network VLAN port that is configured as an endpoint. The e flag only 

appears in the 

show vlan

 display for network VLANs.

To view all FDB entries including those created for a PVLAN, enter the following command:

show fdb {blackhole {netlogin [all | mac-based-vlans]} | hardware <mac_addr> 

{vlan} <vlan_name> slot [all | <slot>] {number <num_entries>} | netlogin [all | 

mac-based-vlans] | permanent {netlogin [all | mac-based-vlans]} | <mac_addr> 

{netlogin [all | mac-based-vlans]} | ports <port_list> {netlogin [all | 

mac-based-vlans]} | vlan <vlan_name> {netlogin [all | mac-based-vlans]}}

The P flag marks additional FDB entries for PVLANs.

PVLAN Configuration Example 1

 shows a PVLAN configuration example for a medical research lab.