Netgear XCM8810 - 8800 SERIES 10-SLOT CHASSIS SWITCH ユーザーズマニュアル
426
|
Chapter 16. Network Login
NETGEAR 8800 User Manual
This section describes the following topics:
Configuring Network Login MAC-Based VLANs
Currently, network login allows only a single, untagged VLAN to exist on a port. This limits the
flexibility for untagged supplicants because they must be in the same VLAN.
flexibility for untagged supplicants because they must be in the same VLAN.
NETGEAR 8800 switches support network login MAC-based VLANs. Network login
MAC-based VLANs allow a port assigned to a VLAN to operate in a MAC-based fashion. This
means that each individual untagged supplicant, identified by its MAC address, can be in
different VLANs.
MAC-based VLANs allow a port assigned to a VLAN to operate in a MAC-based fashion. This
means that each individual untagged supplicant, identified by its MAC address, can be in
different VLANs.
Network login MAC-based VLAN utilizes VSA information from both the network login local
database and the RADIUS server. After successfully performing the Campus mode
operation, the supplicant is added untagged to the destination VLAN.
database and the RADIUS server. After successfully performing the Campus mode
operation, the supplicant is added untagged to the destination VLAN.
To support this feature, you must configure the network login port’s mode of operation.
Network Login MAC-Based VLANs Rules and Restrictions
This section summarizes the rules and restrictions for configuring network login MAC-based
VLANs:
VLANs:
•
You must configure and enable network login on the switch and before you configure
network login MAC-based VLANs.
If you attempt to configure the port’s mode of operation before enabling network login, the
switch displays an error message similar to the following:
switch displays an error message similar to the following:
ERROR: The following ports do not have NetLogin enabled; 1
Configuring the Port Mode
To support network login MAC-based VLANs on a network login port, you must configure that
port’s mode of operation. To specify MAC-based operation, use the following command and
specify
port’s mode of operation. To specify MAC-based operation, use the following command and
specify
mac-based-vlans
:
configure netlogin ports [all | <port_list>] mode [mac-based-vlans |
port-based-vlans]
By default, the network login port’s mode of operation is
port-based-vlans
. If you modify the
mode of operation to
mac-based-vlans
and later disable all network login protocols on that
port, the mode of operation automatically returns to
port-based-vlans
.
When you change the network login port’s mode of operation, the switch deletes all currently
known supplicants from the port and restores all VLANs associated with that port to their
known supplicants from the port and restores all VLANs associated with that port to their