Netgear XCM8810 - 8800 SERIES 10-SLOT CHASSIS SWITCH ユーザーズマニュアル

Based on the profiles listed in the example above and the users listed in the example in 

on page 490, command authorization for this example operates as 

follows:

User 

eric

 is able to log in, but is unable to perform any commands, because he has no 

valid profile assigned.

Users 

albert

 and 

lulu 

are assigned to 

PROFILE1

, which uses the 

deny

 keyword, so their 

use of commands is as follows:

Cannot use any command starting with 

enable

.

Cannot use the 

disable ipforwarding

 

command.

Cannot use a 

show switch

 command.

Can perform all other commands.

User 

gerald

 is assigned to 

PROFILE2

, so his use of commands is as follows:

Can use any 

enable

 command, the 

clear counters

 command, and the 

show 

management

 command.

Cannot execute any other commands on the switch.

Additional RADIUS Configuration Examples

RADIUS server. This section provides examples and guidelines for the following tasks:

RADIUS is a client/server protocol based on UDP. The example presented in this section 
describes a RADIUS server that is a daemon process running on a Linux server.

The following example shows how to install and test a FreeRADIUS server:

tar -zxvf freeradius-1.0.2.tar.gz        (extract with gunzip and tar)

./configure

make

make install                             (run this command as root)

radiusd                                  (start RADIUS server, or...)

radiusd -X                               (start RADIUS server in debug mode)

radtest test test localhost 0 testing123 (test RADIUS server)

If radtest receives a response, the FreeRADIUS server is up and running.